Connecting With A Vcr - Sony VPL-X600U Manual De Instrucciones

Connecting

Connecting with a VCR

Rear
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
1) When both the S VIDEO and VIDEO jacks are connected to the external equipment, the input signal from the S VIDEO jack is selected.
20
(EN)
This section describes how to connect the projector with a VCR and
external active speakers.
For details on how to connect a computer, see page 18 (EN), and to
connect other equipment, see page 21 (EN).
Also refer to the instruction manuals of equipment to be connected.
When making connections, be sure to:
• turn off all equipment before making any connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are not fully inserted
often generate noise. When pulling out a cable, be sure to pull it out from
the plug, not the cable itself.
VCR
S-Video cable
(not supplied)
AUDIO OUT
Note on the VPL-X600E model
The optional IFB-X600E Interface Board is required for
the VIDEO IN and AUDIO IN jacks.
Active speakers
to audio/video
to S video
outputs 1)
1)
output
Audio/video cable
(VPL-X600U/M: supplied
VPL-X600E: supplied with the
IFB-X600E Interface Board)
VIDEO IN AUDIO IN
(MONO)
S VIDEO VIDEO L R
CONTROL S IN
PLUG IN POWER
INPUT A INPUT B
MOUSE AUDIO MOUSE AUDIO