Projecting - Sony VPL-X600U Manual De Instrucciones

Projecting

STANDBY indicator
LAMP/COVER TEMP/FAN STANDBY
LIGHT +
VOLUME
4
–
PATTERN
APA V
B b
v
RESET
APA key
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
22
(EN)
5
4, 6
ON indicator
POWER
SAVING ON
2
I / u
3
INPUT
MENU
ENTER
1
After all equipment is connected completely, plug the AC power cord
into the wall outlet.
The STANDBY indicator lights in red and the projector goes into the
standby mode.
2
Press the I / u key on the Remote Commander or on the control panel.
The ON indicator lights in green.
3
Turn on equipment connected to the projector. Press the INPUT key on
the Remote Commander or on the control panel to select the input
source.
INPUT A: Selects audio and video signals input from the INPUT A
INPUT B: Selects audio and video signals input from the INPUT B
VIDEO: Selects audio and video signals input from the VIDEO IN/
Note on the VPL-X600E model
The optional IFB-X600E Interface Board is required for selecting
VIDEO.
COMMAND I / u
OFF ON
MUTING
INPUT
AUDIO PICTURE
APA
APA key
MENU LASER
V
B b
ENTER v R CLICK
RESET
VOLUME
+
–
connector.
connector.
AUDIO IN jacks.
(If you connect to both the S VIDEO and VIDEO jacks, the
signal from the S VIDEO jack is selected.)
Rear remote control detector
1
Front remote control detector
2
3