Assembly Instructions - Dyna-Glo DGP350NP Manual Del Usuario E Instrucciones Para El Funcionamiento

Step 1
1. Secure each locking caster (2) to the back side (side that is
beveled for access to locking mechanism when assembled and
upright) of the bottom shelf (1) using four screws (A) four spring
washers (F) ) and four flat washers (G). Then tighten all screws.
2. Install the casters (3) to the front side
(not beveled) of bottom shelf using four
screws (A) four spring washers (F) ) and
four flat washers (G). Then tighten all screws.
Hardware Used
A
F
G
Step 2
First, remove the pins (7) from
the cylinder holder (6). Insert the
cylinder holder (6) through the
holes in the bracket pre-attached
to the cart right side panel (5).
Lock in place with the pins (7).
Parts Used
6
7
LP Gas Grill

ASSEMBLY INSTRUCTIONS

M6x12
16 pc
Scr ew
6MM
16 pc
Spring Washer
6MM
16 pc
Flat Washer
5
Cylinder
1 pc
Holder
6
Pin 2 pc
Back Side Beveled Back Side Beveled
5
6
7
3 2
1
A
F
G
7
9