Eneral Safety Informations; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; Eclaration Of Incorporation - SUHNER ABRASIVE TURBO TRIM SH 1300 Documentación Técnica

1. n
1.1 g

enerAl sAfety infOrmAtiOns

This operation manual is applicable for the hand piece SH
1300. The hand piece may only be handled by personnel
who are qualified. Suitable safety and hygiene measures
must be taken.
It is imperative that you observe the safety instruc-
tions provided separately.
The working environment must be kept clean and
well illuminated. Keep away persons in the vicinity when
you are using the hand piece. Wear tight fitting clothing
and secure long hair.
Very sharp blade!
Use only food grade (FDA approved) lubricants,
e.g. TURBO LUBE GREASE (Art.-Nr. 60000078),
TURBO LUBE SPRAY (Art.-Nr. 60000077). Do not
place the hand piece on a hard surface, but only in the
provided receiver.
1.2 u
se Of the mAchine fOr purpOses fOr
which it is intended
These hand piece is designed to process rough cut meat
on an industrial scale. It can be used to remove fat, tissue,
bones, and other small parts and to detach meat from
other animal parts.
1.3 i
ncOrrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d

eclArAtiOn Of incOrpOrAtiOn

The manufacturer Otto Suhner AG of Industriestrasse 10,
CH-5242 Lupfig, hereby declares for the partly completed
machinery (see reverse side for type and serial no.) that
the following fundamental requirements of the Directive
2006/42/EC are applied and fulfilled in accordance with
Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7, 1.3.8.1, 1.5.1,
1.5.4, and 1.6.1. Technical documentation was generated
for the partly completed machinery in accordance with
Annex VII of the Machinery Directive. Document Agent:
M. Voyame. Authorised sites are provided with this techni-
cal documentation in paper or electronic form on justified
request. This partly completed machinery may be put into
operation only when the machine in which the partly com-
pleted machinery is to be incorporated has been ascer-
tained to fulfil the conditions under the Machinery Direc-
tive. CH-Brugg, 06/2017.
M. Voyame/Division managerr
18
S
oteS on afety
2. c
2.1 A

ssemBly instructiOns

It is imperative that you read Sections 2 and 3 be-
fore starting up the hand piece.
Use hand piece and shaft only when they are in
perfect working order.
Replace blades only when the hand piece has
been detached.
Always work with suitable protective equipment
(chainmail glove / protective clothing). Observe
the rules and regulations applying in your country.
Very sharp blade!
2.1.1 c
Onnecting the hAnd piece tO the flexiBle shAft
Introduce the flexible shaft into the hand piece. Twist the
turnlock fastener to secure the flexible shaft. If you can-
not completely screw in the hand piece, turn the blade
slightly.
Very sharp blade!
2.1.2 Detaching/connecting the depth gauge
Use an allen key to loosen the setscrews.
ommiSSioning