TECNOMOTOR ZIPTEC II TM 530 Manual De Instrucciones página 102

TM 530
Produzido por Tecnomotor Eletrônica do Brasil S/A - REPRODUÇÃO PROIBIDA - Eventuais erros ou defeitos favor comunicar tecnomotor@tecnomotor.com.br
10 - Realizations measurements kilovolt
Turn on the connection to the connector clamps accessories Ziptec.
Place the selector switch in the function Osc.
Position the clamp capacitor (PC - red) around a spark plug wire and connect the
black clamp to a ground point as the negative pole of the vehicle battery.
Select key gripper assembly into position KV.
The value of peak voltage is shown in kilovolts. Also note that the bar graph is
shown.
11 - Freezing the Readings
In the multimeter functions, it is possible to immobilize (freeze) the readings
displayed at any time.
immobilizes the screen. Appears hold on the top right of the
The key
reading area.
The screen illumination (backlight) is driven by a few seconds.
Button again resumes the measurement.
You can use this function to maintain accurate readings taken in a situation
difficult to access for further verification.
100