TECNOMOTOR ZIPTEC II TM 530 Manual De Instrucciones página 93

TM 530
Produzido por Tecnomotor Eletrônica do Brasil S/A - REPRODUÇÃO PROIBIDA - Eventuais erros ou defeitos favor comunicar tecnomotor@tecnomotor.com.br
2 - Achievements measurement of RPM
2.1 - Rotation by electrical signal (negative coil, pulses RPM, etc..)
Turn on the connection to the probe connector accessories Ziptec.
Position the switch on Pulse function.
If necessary press the until the measurement screen RPM.
Connect the black clamp to a grounding point, as the negative pole of the vehicle
battery. With the key , setting the number of cylinders in accordance
with the vehicle engine.
repeatedly until --E.
If the ignition system is static press
Touch the probe Ziptec the wire or terminal to be measured and to keep in touch.
The amount of rotation is shown in revolutions per minute. Also note that the bar
graph is shown.
Remember: You can always make the measurements through the red test
lead connected to the positive terminal of the connection to the probe.
91