Adjusting the disk pressure on the ground______________________________________________________________
To adjust the disk pressure, proceed as outlined below.
1) Turn the handwheel (H) to increase or decrease the
disk pressure on the ground.
Adjusting the depth, tilt, and longitudinal displacement of the disk _________________________________________
To adjust the disk, proceed as outlined below.
1) Loosen the screw (A).
- Raise or lower the disk to increase or decrease the
amount of soil to ridge over the mulch sheet.
- Alter the angle of the disk to increase or decrease the
width of the ridging over the sheet.
- Move the disk closer to or away from the pressure
wheel to bring forward or delay the start of the ridg-
ing.
2) Tighten the screw (A).
If the pointer (C) prevents the disk lowering as desired,
proceed as described.
1) Loosen the screw (B) and lift the pointer (C) without
turning it. The pointer must not be turned as it would
desynchronise the initial inclination of the disk in re-
lation to the gauge scale (D).
2) Tighten the screw (A).
Repeat the same procedure for the other disk.
English language
ADJUSTMENT INFORMATION
UN41-0365AL
UN41-0366AL
22
5
Use and maintenance