Publicidad
V-Groover
S I M P L E X
Adjustments
V-Groove Width Adjustments
To adjust width, loosen the width adjustment lock lever turning coun-
terclockwise. Slide adjustable blade holder to desired width setting.
Tighten lever to lock. Use width scale as a reference. (Maximum V-
Groove width setting is 5/64" - minimum width is 1/32"). Fig 12.
Overcut Adjustment
1 Overcut Adjustment Screw:
a. Turn screw clockwise to increase overcut (Fig. 13).
b. Turn screw counterclockwise to decrease overcut
(Fig. 13).
2 Overcut Adjustment Post:
a. To adjust for longer overcut, visually note overcut adjustment
post (by looking straight down at post) and turn post from
under side with screwdriver toward position shown in Fig. 14.
b. To shorten overcut, turn overcut adjustment post toward posi-
tion shown in Fig. 15.
Fig. 15
5
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , W a u c o n d a , I L 6 0 0 8 4 T o l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w . l o g a n g r a p h i c . c o m
SHORTER
OVERCUT
NYLON GUIDE
OVERCUT
ADJUSTMENT
WIDTH
ADJUSTMENT
LOCK LEVER
WIDTH
SCALE
OVERCUT
ADJUSTMENT
SCREW
Fig. 14
NYLON GUIDE
M O D E L 7 0 3
ADJUSTABLE
BLADE HOLDER
Fig. 12
OVERCUT
ADJUSTMENT
POST
Fig. 13
OVERCUT POST
LONGER
OVERCUT
Publicidad
