System Check; Message Center - Ford Explorer 2007 Manual Del Usuario

Driver Controls

System check

Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when "SYSTEM CHECK /
HOLD RESET" is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
"OIL XXX% RESET IF NEW".
111
2007 Explorer (exp)
Owners Guide (post-2002-fmt)
USA (fus)