SATA AE1016H Instrucciones De Uso página 56

4.2.11
Remove the vertical cap while supporting the vertical shaft to prevent the vertical shaft from slipping, causing
damage to the machine or personal accidents.
4.2.12
4.2.13 Installation of air source triplet
56
AE1016H/AE1016H-3
中文
EN DE RU KO
Remove the internal hexagon screws on the
vertical cap with 8# internal hexagon wrench
as shown in Fig. 4-8, install the vertical spring
into the hexagonal shaft, and then refit the
vertical cap to the hexagonal shaft.
Fig. 4-8
Install the push-pull arm guard: take out the
protective cover and mounting screws from
the accessory box and install the protective
cover into the hexagonal shaft (Fig. 4-9). Load
the half-round head screws from the outside
of protective cover, fit the fixing sleeve and
then fix the screws inside the mounting hole.
Fig. 4-9
First take out the air source connector (Fig.
4-10) from the accessory box and install it at
the intake end of triplet (Fig. 4-11). After the
installation, insert the quick connector of air
source into the air source connector.
Note: The air supply shall be cut off for the
installation of air source!
Fig. 4-10
PT JA ES