Prepare Irrigator For Use; Replacing The Water Filters - Interacoustics Aqua Stim Manual De Instrucciones

4.7.3 Prepare irrigator for use

1. Drain the irrigator by pushing the Time Up/Down arrows and following instructions on the irrigator.
2. Remove handle and drain water from the handle.
3. Inspect filter on the red tube of the handle assembly. Replace the cone insert if dirty.
4. Fill the external water tank with fresh water.

4.8 Replacing the water filters

This pick-up filter can be rinsed off if it gets clogged. However, if the filter needs replaced, it
can be pulled off the end of the clear intake tube inside the external tank.
If the water filter assembly is not damaged, then the water filter assembly can be
disconnected from the red tube and the filter cone replaced. To remove the tubes, push on the small ring
next to the tube using two finger tips and pull gently on the tube. The caps can be removed with a 9/16"
socket wrench or crescent wrench. The water filter assembly should have an arrow sticker that shows the
direction of the water flow – the water will flow from the tapered end of the filter to the larger end for
maximum filtration. Use the wrench to open the side where the arrow points. The filter can be removed
with a tap of the filter assembly against the table.
After replacing the filter, close the water filter
assembly and tighten just past finger tight using
the socket wrench or crescent wrench. Check
direction of the filter cone in the water filter
assembly. The tapered end should point towards
the irrigator as water is pushed into this tube from
the irrigator. Add the new water filter assembly to
the Red line. Trim the red tube on filter assembly
to the same length as the blue tube before
connecting to the irrigator.
Aqua Stim Water Irrigator – Instructions for Use - EN Page 14