Waeco MAGIC WATCH MWE-850-4XXL Instrucciones De Montaje Y De Uso página 39

MWE-850-XXL-4.book Seite 39 Freitag, 8. Juli 2005 10:29 10
All manuals and user guides at all-guides.com
magic watch
➤ For a more accurate fit, slant the drill downwards slightly on the inside of
the bumper when drilling the hole. The sensor cover can now be easily
inserted at a downward angle.
➤ Guide the cables of the sensors through the corresponding hole.
➤ Insert each sensor into the corresponding drill hole until it latches
into place.
6.3 Laying the sensor extension cables
When laying cables, ensure that:
They are not kinked or twisted
They do not rub on edges
They are not laid in sharp edged ducts without protection (see 3, page 4).
The plugs must be connected with the correct polarity. A blocking pin
prevents reverse polarity (see c A, page 6).
Make sure the locking pin catches (see c A, page 6). Only then is
trouble-free operation guaranteed.
To release the connection press the holder and pull the plug and
socket apart (see c B, page 6).
If the sensor cable is not long enough, you can order one-metre extension
cables (MWCD-1) as accessories.
Note
The extension cables are marked: L (left), CL (centre left),
R (right), CR (centre right).
This marking helps you connect them to the control electronics
to ensure that the display is correct.
Caution!
Before making any drill holes, ensure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
➤ Take suitable precautions to protect holes made in the bodywork from
water penetration, for example by spraying the cable and the sleeve
with sealant.
Installing MAGIC WATCH
39