Waeco MAGIC WATCH MWE-850-4XXL Instrucciones De Montaje Y De Uso página 40

MWE-850-XXL-4.book Seite 40 Freitag, 8. Juli 2005 10:29 10
All manuals and user guides at all-guides.com
Installing MAGIC WATCH
➤ Where possible, use existing rubber bungs in the boot for laying the
extension cables.
If there are no rubber bungs, make a suitable hole with a diameter of
around 13 mm and insert a cable sleeve.
Note
Pull the plugs of the extension cables through the cable sleeve
before inserting the sleeve in the body work.
➤ Lay out the extension cables in the boot so that they cannot be damaged
under any circumstances (e.g. by flying grit).
➤ Carefully fasten the extension cables behind the bumper.
➤ Insert the sensor plugs into the sockets of the corresponding extension
cables (see d A, page 7).
6.4 Fastening the control box
Note the following information when selecting a location to mount the
control box:
Note the length of the sensor cables.
The control box may not be damaged if you have luggage or objects in
the boot.
➤ Fasten the control electronics to a suitable place in the boot.
The control box should not be exposed to any moisture.
Note
The extension cables are marked: L (left), CL (centre left),
R (right), CR (centre right).
This marking helps you connect them to the control electronics
to ensure that the display is correct. These markings can also
be found on the control electronics.
The plug polarities cannot be reversed: they can be only be
plugged into the connection in one way.
➤ Insert the plugs of the sensor extension cables into the corresponding
sockets on the control electronics (see d B, page 7).
Make sure the locking pin catches.
40
magic watch