Using Fan Without Light Kit (Optional) - Harbor Breeze E-BFT52CB5C1 Manual Del Usuario

FINAL INSTALLATION
8. Locate white washer, finial plate (K), and finial (L) that
were removed in Step 4. Place white washer inside glass
shade (F) over center hole. Raise glass shade (F) in order
to guide pull chains through corresponding holes at the
bottom of the glass shade (F). Align hole in center of glass
shade (F) with threaded rod on light kit fitter (D) and push
up gently until threaded rod comes through hole. (Be sure
pull chain for fan operation does not rub against bulbs
during operation.) (Fig. 8)
Align hole in center of finial plate (K) with threaded rod,
allowing the pull chains to come through appropriate holes
in finial plate (K) and push up. Thread center pull chain
through hole in finial (L) and secure glass shade (F) by
tightening finial (L). (Fig. 8)
Note: Do not overtighten finial (L) as glass may crack or
break.
9. Attach pull chain extensions (J) supplied in one of the
hardware packs or custom pull chain extensions (not
included) to fan and light pull chains. (Fig. 9)

USING FAN WITHOUT LIGHT KIT (OPTIONAL)

1. If you do NOT wish to use the light kit,
remove the hex nut and lock washer from the
threaded rod at the top of the light kit fitter (D).
Unscrew the switch housing cap to remove it from
the light kit fitter (D), and then gently feed the
BLACK and WHITE wires from the light kit fitter (D)
through the hole in the middle of the switch housing
cap. (Fig. 1)
Lock Washer
15
Fig. 8
E
F
L
Fig. 9
J
Fig. 1
WHITE
BLACK
Hex Nut
D
D
White
Washer
K
J
Switch
Housing
Cap