INSTALLING FAN WITHOUT INCLUDED LIGHT KIT (OPTIONAL)
1.
If you do NOT wish to use the light kit,
remove three switch housing plate screws (W)
from underside of motor. (Fig. 1)
2. Connect male plug from motor housing (D) to
female plug from switch housing (F), matching
up the colors on the male plug with the colors
on the female plug for correct fit. (Fig. 2) Make
sure that plugs connect tightly.
Align holes in switch housing (F) with holes in
switch housing plate. Re-insert switch housing
plate screws (W) that were previously removed.
Tighten all three switch housing plate screws
(W) securely. (Fig. 2)
3. Attach one of the pull chain extensions (I)
supplied in the hardware packs or a custom pull
chain extension (not included) to fan pull chain.
(Fig. 3)
NOTE: This fan is remote control adaptable
(remote control not included). Any remote
control used with this fan MUST be UL-approved
for DAMP LOCATIONS.
1
2
Switch
Housing
Plate
3
17
W
Switch
Housing
Plate
Male Plug
Female Plug
F
I
D
D
W
D