Final Installation - Harbor Breeze E-BFT52CB5C1 Manual Del Usuario

WIRING
2. Wrap electrical tape around each individual wire
connector (EE) down to the wire as shown in Fig. 2.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of box
from the black and blue (if applicable) connections.
Turn spliced/taped wires upward and gently push wires
and wire connectors (EE) into outlet box.
IMPORTANT: Using a full range dimmer switch to
control fan speed will cause a loud humming noise
from fan. To reduce the risk of fire or electric shock,
do NOT use a full range dimmer switch to control fan
speed. (Fig. 3)

FINAL INSTALLATION

1. Lift canopy (B) to mounting bracket (C), aligning
slotted holes in canopy (B) with loosened canopy
mounting screws (FF) in mounting bracket (C). Twist
canopy (B) to lock. Re-insert the two canopy
mounting screws (FF) that were removed in Step 4
on page 7 and tighten all canopy mounting screws
(FF) securely. (Fig. 1)
Hardware Used
E3 Wire Connector
EE
Hardware Used
FF
Canopy Mounting Screw
12
Fig. 2
EE
Fig. 3
Dimmer
Speed
Switch
Switch
For illustrative purposes only--not
intended to cover all types of controls
Fig. 1
FF
A
EE
EE
x 4
3
2
1
FF
B
x 4