Siemens SIPART PS2 6DR5.1-E Instrucciones De Operación página 24

CAUTION
Maximum AC/DC switching voltage with UL approval E344532
The mechanical limit switch module 6DR4004-6K is approved for use for positioners with UL approval. The maximum
supply voltage in this case is 30 V AC/DC.
The mechanical limit switch module 6DR4004-8K is not approved for use for positioners with UL approval.
If this information is ignored, the UL approval for the mechanical limit switch module for the positioner becomes invalid.
①
Non-hazardous area
②
Hazardous area
③
Mechanical limit switch module
④
Fault message
Figure 4-10 Mechanical limit switch module
Procedure
①
1. Loosen the screw
2. Pull the transparent cover
3. Tighten every cable in the corresponding terminal.
4. Slide the transparent cover
①
5. Tighten the screw
6. Connect the cables of each switch to the lug of the printed circuit board in pairs. Use the provided cable ties
purpose.
22
on the transparent cover
②
up to the front end stop.
②
up to the end stop of the basic electronics.
②
of the transparent cover
⑤
Limit
⑥
Switching amplifier
⑦
Switching output
②
.
.
③
for this
SIPART PS2 (6DR5...)
A5E03436620-AB, 01/2017