BD Veritor Plus Instrucciones De Uso página 14

BD Veritor™ Plus Analyzer Instructions for Use
If any items are missing, contact your BD representative. (See page 213 for contact information.)
Analyzer Unpacking and Setup
1 Before using the BD Veritor™ Plus Analyzer, visually inspect the contents for damage. If damage is apparent, contact your
BD representative or BD Technical Services.
2 The BD Veritor™ Plus Analyzer ships with an adhesive-backed USB Port Unlock Barcode label, which is used on Analyzers that are
configured with a BD Veritor™ barcode scanning module. BD recommends affixing this label to the space indicated on the cover page
of this manual or storage in a secure location of your choice for future use. Instructions for using the USB Unlock Barcode can be
found in section 4.6. The optional modules may not be available in all regions; please contact your local BD representative for
availability.
3 Remove the Analyzer and power adapter from the protective wrapping. BD recommends retaining the packing materials in a safe
location. The provided power adapter rated output is 5V 3A, 15W (Refer to the figure below).
4 Refer to the figure below. The North American plug is used to illustrate the installation of region specific blade adapters onto the power
supply. Select the blade adapter that is appropriate for your region.
5 Slide the retaining clip (1) down on the power adapter.
6 Insert the notched end (2) of the blade adapter into the top of the power adapter at a 30–60 degree angle.
7 Push the bottom (3) of the blade adapter into the power adapter.
8 Slide the retaining clip (1) up to lock the blade adapter in place.
THE ANALYZER WILL NOT CHARGE IF THE POWER ADAPTER OUTPUT IS GREATER THAN 5V 3A, 15W. IF THE
BATTERY ICON IS FLASHING OR THE BATTERY CHARGE IS REQUIRED, MAKE SURE THE ANALYZER IS
9 Insert the coaxial power connector (identified by the BD label near the connector) into the round port on the back of the Analyzer, and
insert the power adapter plug into an electrical outlet.
10 Perform a verification test as described in section 5.1.1.
14
NOTE
CAUTION
CONNECTED TO THE BD SUPPLIED POWER ADAPTER.