Wiring; Final Installation - Harbor Breeze 00830 Manual De Instrucciones

WIRING

1. Connect the BLACK and BLUE wires from fan to
the house BLACK wire. Connect the WHITE wire
from fan to the house WHITE wire. Connect all
GROUNDED (GREEN) wires together from fan to
the house GREEN/GROUNDED wire.
Note: Black wire is hot power for fan. Blue wire is
hot power for light kit in case of future light kit
installation. White wire is common for fan and light kit.
Green wire is grounded wire. lf house wires are
different colors than referred to above, stop
immediately. It is recommended a professional
electrician to determine proper wiring.
2. To connect wires, twist wire ends together and
screw wire with wire connectors (AA) on in a
clockwise direction. Tape the wire connectors (AA) and
wires together. The wires should be spread apart with
the grounded conductor and the equipment-grounding
conductor on one side of the outlet box and the
ungrounded conductor on the other side of the outlet
box. Be sure no bare wire or wire strands are visible
after making connection. Place green and white
connections on opposite side of box from the black
and blue connections. The splices should be turned
upward and pushed carefully up into the outlet box.
Hardware Used
AA
Wire connector

FINAL INSTALLATION

If you installed the fan with "Closemount Style Fan Mounting", continue to Steps 1 and 2. If
you installed the fan with "Downrod Style Fan Mounting", skip to Step 3.
1. Remove the fan from the hook on the mounting bracket
(A). Align the locking slots of the canopy (B) with the two
screws in the mounting bracket (A). Push up to engage
the slots and turn clockwise to lock in place. Immediately
1 1
Grounded/Green
White
White
Black
Black
Grounded/
Blue
Green
2
x 4
AA
1
outlet
box
hook
locking
slots
Lowes.com/harborbreeze Lowes.com/harborbreeze
10
FINAL INSTALLATION
2. Install the two screws that were removed in previous step
and tighten securely.
You may now proceed to the Step 4.
3. Directly align the locking slots of the canopy (B) with the
two screws in the mounting bracket (A). Push up to
engage the slots and turn clockwise to lock in place.
screws that were removed in previous step and tighten
securely.
4. Attach a blade (G) to a blade bracket (F) using the blade
screw (CC).
screws
A
Hardware Used
Blade screw
CC
B
2
outlet box
B
3 screw
4
CC
×16
G
Lowes.com/harborbreeze Lowes.com/harborbreeze
11
screw
outlet box
B
F