Operation Instructions; Care And Maintenance; Troubleshooting - Harbor Breeze 00830 Manual De Instrucciones

FINAL INSTALLATION
5. Fasten the blade bracket (F) to the motor by inserting
the alignment post into the slot on the bottom of the
motor housing (H) and tightening the blade bracket
screws with washers.
Please note that the blade bracket screws with washers
are pre-installed into the blade bracket (F). Repeat Steps
4 and 5 for the remaining blade brackets (F).
6. Attach the fan pull chain extension (BB).
Hardware Used
Fan pull chain extension
BB
5
F
slot
alignment
post
screw with
washer
6
x 1
BB
Lowes.com/harborbreeze Lowes.com/harborbreeze
12
OPERATING INSTRUCTIONS
PULL CHAIN: The fan pull chain is for motor speed control: High, Medium, Low and Off. Pull the
chain once for each position.
REVERSE SWITCH:
When the season changes, you may want to change to the direction your fan
spins. To switch between clockwise and counterclockwise rotation, flip the fan reversal switch.
Note: Wait for fan to stop before reversing the switch.
H
A. In cooler weather, clockwise rotation creates an upward air flow, which moves hot air from the
ceiling into the room. Push the switch UP.
B. In warmer weather, counterclockwise rotation creates a downward air flow, which cools the air.
Push the switch DOWN.

CARE AND MAINTENANCE

• To reduce the risk of fire, electric shock or injury to persons, maintain this fan.
• Important: Shut off main power supply before beginning any maintenance.
• Do not use water or detergents when cleaning the fan or fan blades. A dry dust cloth or lightly
dampened cloth will be suitable for most cleaning.
• Clean fan housing with only a soft brush or lint-free cloth to avoid scratching the finish. Clean
blades with a lint-free cloth. You may occasionally apply a light coat of furniture polish to blades for
added protection.
• At least twice each year, tighten all screws and lower canopy to check mounting bracket screws
and downrod assembly.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
Fan does not move. 1. Chain switch is "off".
2. Faulty wire connection.
3. Reverse switch not engaged.
Noisy operation. 1. Blades are loose.
2. Cracked blade.
3. Unapproved speed control.
Excessive wobbling. 1. Blades are loose.
2. Blade brackets incorrectly attached. 2. Reinstall blade brackets.
3. Unbalanced blades.
4. Fan not securely mounted.
5. Fan too close to vaulted ceiling.
CORRECTIVE ACTION
1. Pull chain switch.
2. Turn power off. Loosen canopy,
check all connections.
3. Push switch firmly either way.
1. Tighten all blade screws.
2. Replace blades (call customer
service).
3. Replace with an approved speed
control device.
1. Tighten all blade screws.
3. Switch with blade from opposite side.
4. Turn power off. Carefully loosen
canopy; remount securely.
5. Lower fan or move it to another
location.
Lowes.com/harborbreeze Lowes.com/harborbreeze
13