Cequent Performance Products Rola Pick-Up-Rack Manual Del Usuario página 5

Please read all instructions carefully before assembly, installation and/or use of this product.
7
• Install crossbars onto Vertical Supports, align carriage bolts with slots in Vertical
Support Flanges.
•
Secure crossbars to supports using the 3/8 flat washer, lock washers and hex nuts
onto carriage bolts.
• Securely tighten all 3/8-16 fasteners (approximately 25 Lb.-Ft. )
•
Confirm position of supports and ensure alignment of supports with bed and
securely tighten clamps.
• Tighten wing nut against bottom of clamp.
Optional permanent mounting
Your Pick-Up-Rack™ can be permanently mounted to your truck if you desire. You will need (8) 3/8-16 Grade 5 hex bolts, (16) 3/8" flat washers
and (8) 3/8 -16 grade "A" lock nuts. Stainless steel hardware is recommended. Start by placing a piece of tape on top of the mounting base.
Mark the tape as shown below. Place the mounting base on the truck and check that there will be no interference where the bolts will be
placed. Remove the base from the truck and drill the (2) 3/8" holes in the marked locations on the base. Mark the truck bed rails using the
drilled base as a template. Then drill the (2) 3/8" holes in truck bed rail, 4 places.
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
Always secure front and rear of long
loads to ends of vehicle for safe
transport. Failure to do so can result
in property damage, personal injury, or in property damage, personal injury, or
death.
1.00"
MINIMUM
3.00"
MAXIMUM
CENTER
OF BED RAIL
(1-1/2" REF.)
Place a 3/8" washer on a 3/8-16 bolt and insert it though the
base and truck bed. Install a 3/8" washer and 3/8-16 nut on
the bolt underneath the bed rail and tighten.
Product Name:
Pick-Up-Rack™
Product Code:
3/8 Flat Washer
3/8 Lock washer
3/8 Hex nut
(8) Places
WARNING
DRILL (1) 3/8" HOLE
THIS LOCATION
DRILL (1) 3/8" HOLE
BETWEEN 1.0" to 3.0"
Page 5 of 6
59742
Buffer strip
Remove end cap and
buffer strip to utilize
Accessory T-Slot in
crossbar
Support
Wing nut
Clamp
REMOVE YOUR RACK AND
ACCESSORIES WHEN NOT
IN USE AND BEFORE
ENTERING AUTOMATIC ENTERING AUTOMATIC
CAR WASHES
1.00"
Support Base
59742N Rev F
Printed in China
CENTER
OF BED RAIL
(1-1/2" REF.)
1-27-14