Vehicle Installation - Cequent Performance Products Rola Pick-Up-Rack Manual Del Usuario

Please read all instructions carefully before assembly, installation and/or use of this product.
Assembly of Vertical Supports
1
2
3/8-16 x 2" carriage bolt
3/8 Lock washer
3/8 Hex nut
(2) Places

Vehicle Installation

3
•
Clean bed rails.
•
Place Vertical Supports onto bed rail in desired location.
The long end of base must point towards the inside of
truck bed.
TIP: Mounting location is different for each bed design and
may require adjustment to avoid interference with
mounting hardware.
** Note: Some bed liners or bedrail covers may require alteration. It may be necessary to cut away a section of the liner on the underside
of the bedrail.
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
Product Name:
Vertical Support
Plastic Cover
¼-20 set screw
Support Base
Page 3 of 6
Pick-Up-Rack™
Product Code:
59742
• Slide plastic cover over vertical support
as shown.
• Slide vertical support and cover into Support
Base.
•
Install two 3/8-16 x 2" long carriage bolts
through the two square holes in back of base
and through vertical support.
• Install the 3/8 lock washers and hex nuts onto
carriage bolts.
• Securely tighten
(approximately 25 Lb.-Ft. )
•
Slide cover into position and secure with
¼-20 set screw using a 1/8" hex key wrench.
DO NOT over tighten.
•
Repeat steps for all four supports.
Wing nut
Clamp
•
Attach clamps and hand tighten.
•
Ensure both support bases are aligned front to
back on bed rail, both sides.
• Leave clamps slightly loose at this step for ease
of crossbar alignment in steps 5 & 7.
all 3/8-16 fasteners
59742N Rev F 1-27-14
Printed in China