Further Information - Medel DISPLAY Manual Del Usuario

EN
Eliminate Fault
Problem
No power.
No display appears on the display screen.
Other possible malfunctions and their elimination
If problems occur when using the device, the following points should be
checked and if necessary, the corresponding measures are to be taken:
Malfunction
The display remains empty when the instrument is
switched on although the batteries are in place.
The pressure does not rise although the pumping ball
is ressed.
Measurement value appear too high or too low

Further information

The level of blood-pressure is subject to fluctuations even with healthy peo-
ple. Important thereby is, that comparable measurements always require
the same conditions (Quiet conditions)!.
If, in spite of observing all these factors, the fluctuations are larger than
15mmHg, and/or you hear irregular pulse tones on several occasions,
please consult your doctor.
26
Causes and Solutions
Replace all the worn batteries with 4 new ones.
Check the battery installation for proper placement of the batteries
polarities.
Remedy
1) Check whether the batteries are installed with the correct polarity and
correct if necessary.
2) If the display is unusual, remove the batteries and then them, or
exchange them for new.
1) Check the connection of the cuff tube and connect properly if
necessary.
2) The cuff could be damaged, change it.
1) Fit the cuff correctly on the arm.
2) Before starting the measurement make sure that the cuff is not fitted
too tightly and that there is no rolled-up sleeve exerting pressure on
the arm above the measuring position. Take off articles of clothing if
necessary.
3) Measure the blood pressure again in complete peace and quiet.