Ating Data; O Perating Conditions; W Orking Instructions; S Witching On/Off - SUHNER BSG 10 Documentación Técnica

under tension as soon as the pressure is removed from
the head piece.
These instructions also apply when you detach the grind-
ing belt.
2.2 r

Ating dAtA

Connection
Maximum speed
Grinding belt
Vibration EN 60745
Weight
The specified vibration value was measured with a
standardised test method and may differ from the
actual operating value. The specified value can be
used for product comparisons or for an introductory as-
sessment of work breaks.
2.3 o
perAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. h
aNDLINg
3.1 w
orking instructions
To achieve an optimum grinding result,
move grinding tool uniformly back and
forth with light pressure.
Excessive pressure lessens the working capability of the
hand tool, as well as the life of the grinding tool.
Grinding belts can move in any direction without warning.
Apply tension uniformly to the fixed contact roller. Tension
on one side has adverse effects on the belt run and leads
to uneven wearing.
Hold the hand tool so that the grinding belt is applied
where it is pulled by the contact roller (driving side).
Adjust the belt run at the smallest speed. The grinding
belt must run over the centre of the contact roller.
Never exceed the max speed of the grinding belt or hand
tool.
Replace a poor running grinding belt.
Never aim the exposed grinding belt side at persons.
Never reach into the exposed grinding belt side.
Work only with the fixed contact roller.
3.2 s on/off
witching
Hold the hand tool firmly.
Switch on the drive.
Conduct the test run at a speed less than 1000 rpm.
Slowly turn the belt adjusting screw to move the belt to the
centre of the contact rollers.
Switch off the drive and repeat the whole process at the
working speed.
Put down the hand tool so that there can be no danger.
Remove the hand tool from the shaft.
G28
-1
7'000min
450mm
2 2
<2.5m/s , K=1.5m/s
4.1 p
1.590kg
must be replaced.
Damaged guards must be replaced.
4.2 r
If despite strict observance of the manufacturing and test-
ing method the hand tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
4.3 w
/o
PERaTIoN
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages.
Complaints can only be honored if the hand tool is re-
turned in the undisassembled condition.
4.4 s
Temperature range during operation: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C.
4.5 d
This hand tool consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the hand tool unusable.
must be disposed of in an environmentally-compatible
recycling process.
The tool still needs time to stop after the machine
has been switched off.
4. S /m
ERvICE
reventive mAintenAnce
Always keep the hand tool clean and in a dry
place.
As soon as contact rollers show signs of wear they
epAir

ArrAnty

torAge
/ e
isposAl nvironmentAl compAtibility
Do not throw the hand tool into the garbage collec-
tion.
According to national regulations this hand tool
aINTENaNCE
19