Legal Notices & Regulatory Information; Weight; 460 X 280 X 330Mm (18 X 11 X 13") - Elcometer 3000 Guia Del Usuario

10 TECHNICAL SPECIFICATION (continued)
10.2 ELCOMETER 3000 MOTORISED CLEMEN UNIT (continued)
Dimensions

Weight

Note: For indoor use only at altitudes up to 2000m (6562ft).
Mains supply fluctuations up to 10% of the nominal voltage.
Temporary overvoltages occurring on the supply.
Can be used in accordance with:
AS/NZS 1580.403.1, BS 3900-E2, DIN 53799, ECCA T12, EN 13523-12, ISO 1518-1:2011,
JIS K 5600-5-5
11 LEGAL NOTICES & REGULATORY INFORMATION
Declaration of Conformity:
The Elcometer 3000 Motorised Clemen Unit complies with the requirements of the following EU Directives:
2014/30/EU Electromagnetic Compatibility
2006/42/EC Machinery Directive, as amended by 2009/127/EC and 2014/33/EU
2011/65/EU Restriction of the use of certain hazardous substances
The CE Declaration of Conformity is available to download via:
www.elcometer.com/images/stories/PDFs/Datasheets/Declaration_of_Conformity/English/DoC_3000_Motorised.pdf
The Elcometer 3000 Motorised Clemen Unit complies with the requirements of the following UK Standards:
Electromagnetic Compatibility Regulations 2016
Supply of Machinery (Safety) Regulations 2008
The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012
The UKCA Declaration of Conformity is available to download via:
www.elcometer.com/images/stories/PDFs/Datasheets/Declaration_of_Conformity/English/DoC_3000_Motorised_UKCA.pdf
This product is Class B, Group 1 ISM equipment according to CISPR 11.
Class B product: Suitable for use in domestic establishments and in establishments directly connected to a low voltage power
supply network which supplies buildings used for domestic purposes.
Group 1 ISM product: A product in which there is intentionally generated and/or used conductively coupled radio frequency
energy which is necessary for the internal functioning of the equipment itself.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
-- Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC RF Exposure requirements for mobile and base station transmission devices, a separation distance of 20 cm
or more should be maintained between the antenna of this device and persons during operation. To ensure compliance,
operation at closer than this distance is not recommended. The antenna(s) used for this transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Modifications not expressly approved by Elcometer Limited could void the user's authority to operate the equipment under
FCC rules.
is a registered trademark of Elcometer Limited, Edge Lane, Manchester, M43 6BU. United Kingdom
R
All other trademarks acknowledged.
The Elcometer 3000 Clemen Unit is packed in a plywood and / or heavy duty cardboard and foam package. It is
recommended that this packaging is retained and reused in the event that the instrument needs to be transported. If the
packaging is disposed of, please ensure that this is done in an environmentally sensitive manner. Consult your local
Environmental Authority for further guidance.
Head-Office: Elcometer Limited, Edge Lane, Manchester, M43 6BU, United Kingdom.
R

460 x 280 x 330mm (18 x 11 x 13")

20kg (44lb)
TMA-0326 Issue 06 - Text with cover 19438