Spares & Accessories; Care & Maintenance - Elcometer 3000 Guia Del Usuario

7 SPARES & ACCESSORIES
7.1 BALL TOOL
Each Elcometer 3000 is supplied with a 1mm (0.04") tungsten carbide
ball tool as standard.
Due to the nature of the test, the ball tool will wear with use. Spare /
replacement tools are available to purchase from Elcometer or your
local Elcometer supplier.
Description
Tungsten Carbide Ball Tool; 1mm (0.04")
7.2 CUTTING TOOL FOR SCRATCH TESTING
Available to purchase as an optional accessory, the cutting tool gives a
much more aggressive scratch than the standard ball tool supplied
with each instrument. When using the cutting tool, follow the same
adjustment procedure and test procedure as given for the standard ball
tool.
Description
Tungsten Carbide Cutting Tool; 2mm (0.08")
7.3 ADJUSTMENT KIT
Available to purchase as an optional accessory for the Elcometer 3000
Motorised Clemen Unit, the adjustment kit allows testing of samples up
to 20mm (0.8") thick - see Section 6.3 'Testing Thick Samples' on page
en-7 for further details.
Description
Adjustment Kit from 5 - 20mm/0.02 - 0.8"
8 CARE & MAINTENANCE
The top of the instrument around the test sample area should be
regularly wiped clean using a dry cloth.
The Elcometer 3000 does not contain any user-serviceable
components. In the unlikely event of a fault, the instrument should be
returned to your local Elcometer supplier or directly to Elcometer.
The warranty will be invalidated if the instrument has been opened.
en-9
R
Part Number
KT003000P021
Part Number
KT003000N001
Part Number
KT003000N015
www.elcometer.com