Troubleshooting - Medela Freestyle Manual De Instrucciones

10. Troubleshooting

Problem
28
If there is low
or no suction
The pump
becomes wet
"Err" + 3 beeps
The mains
adapter symbol
flashes
The pump does
not switch on
The battery
indicator flashes
with four bars
Solution
Check all connections.
Engage cap correctly at the three connection points.
Hold the breast shield, not the connector or bottle, while expressing.
Ensure the breast shield forms a complete seal around the breast.
During single pumping, insert the unused tubing into the tubing
holder. Do not kink the tubing.
There should be no water in the tubing.
All components must be completely dry.
Unplug the mains adapter from the socket.
Switch off the pump.
Do not place the pump upside down. Control panel must point
upwards.
Store the pump in a dry, warm place for 24 hours.
Note:
Do not expose the pump to direct sunlight.
Do not accelerate the drying process by use of heat.
Contact your Medela dealer or the store where you bought
the pump.
Contact your Medela dealer or the store where you bought the
pump.
Contact your Medela dealer or the store where you bought the
pump.