Olsen VERSATILE Manual Del Usuario página 11

The double bracket locks allow the coupling of 2
accessories, taking up less space on the side rails. The
plastic handles (1) allow height and rotation on the
shaft (distance the accessory to seat) adjustment,
while the metallic lever (3) allows the bracket lock
adjustment on the side rails.
Simply turn counterclockwise to loosen and
clockwise to lock.
To adjust the bracket locks position on the side rail, pull the metal lever (3) counterclockwise. Adjust the
attachment to the desired position and press the metal lever (3) clockwise.
Note: the metal lever (3) moves only in the area indicated in the figure above. To turn it the metal lever (3)
clockwise, push it upwards causing the lever to pass through the metallic knob's axis (2), and then rotate it
again.
The Colposcope holder is attached to the metal support (4) of
the upholstered leg rest or knee support, optimizing the
professional's work space. This accessory can receive Colposcopes
with pin fitting up to 22.5 mm diameter (7/8").
It has arm (3) with free joint, allowing better positioning of the
Colposcope (5).
To attach the Colposcope: fit it and turn the knob (1)
clockwise by locking it in the desired position.
To adjust the height (6): turn the knob (2) to loosen the regulatory bar, place the Colposcope at the
requested height and turn the knob (2) clockwise to lock in position.
They offer support for the heels and are available with double bracket locks (3) that allow the
simultaneous fixation of the heels support (1) and the leg (section 5.8) rest or knees support (section 5.14).
The heels support (2) can be adjusted for height, heel pads position and movement on the side rails.
In addition to bracket locks adjustments, heel supports (2) can be adjusted for the heel pad distance
according to the patient profile or procedure to be
performed.
To fix the heel
support (2): fit
support (2) into
holes (4) along the metal
support (1) according to
the desired distance.
the
the
11