Connecting The High-Pressure Washer To Another; Water Supply - Stihl RE 90 Manual De Instrucciones

English
► Unscrew the connector (1).
► Screw the water filter (2) onto the water supply and tighten
by hand.
► Screw the connector (1) onto the water filter (2) and
tighten by hand.
Connecting the water hose
The water hose must meet the following requirements:
– The water hose has a diameter of 1/2".
– The water hose is between 10 m and 25 m long.
► Connect the water hose to a tap.
► Turn on the water tap fully and flush the water hose with
water.
Sand and dirt will be flushed out of the water hose. The
water hose will be vented.
► Turn off tap.
2
1
54
1
2
► Push the coupling (1) onto the connector (2).
The coupling (1) engages with an audible click.
► Turn tap fully on.
► If the spray lance is attached to the spray gun: Remove
the spray lance.
► Squeeze the spray gun trigger until an even water jet is
delivered from the spray gun.
► Release the spray gun trigger.
► Lock the spray gun trigger.
► Attach the spray lance.
► Attach the nozzle.
Removing the water hose
2
1
► Turn off tap.
► To unlock the coupling: Pull the ring (1) or twist and hold it.
► Pull the coupling off the connector (2).
8.2 Connecting the high-pressure washer to
another water supply
The high-pressure washer can draw in water from water
butts, storage tanks and flowing or still rivers and lakes.
8 Connecting to a water source
0458-002-9821-A