Nogueira FTN-2500 Manual De Instrucciones página 176

4. Preparation
ƒ After placing the cardan, fasten the chains
in a way that allows the articulation in any
working condition and transportation.
ƒ You must observe the length of the cardan
shaft whenever you use a different tractor
model.
ƒ It is the Authorized Dealer sole responsibility
to perform the cardan shaft preparation
and the first activation of the machine.
ƒ After coupling, make sure that the cardan
shaft is properly locked in the machine
and tractor shafts. Release of the cardan
shaft during operation may damage the
machine and cause a serious accident if
someone is struck by it.
ƒ Do not enter the cardan shaft work area
while the machine is in motion, any
contact with the cardan shaft can cause
a serious accident.
ƒ Do not wear wide clothes with belts or
parts that may catch on the cardan's
moving parts.
ƒ Never use the cardan without its protective
cover.
IMPORTANT!
Do not work with the cardan shaft with
an angle above 15
In normal working conditions, with the
implement in its horizontal position and being
shifted in a straight line, the contact surface
between the tube and the bar must be 2/3 of
the minimum length of the cardan.
In a more critic situation, the measure of this
overlap must be at least 1/3 of the minimum
length of the cardan.
52
CAUTION!
.
o
Instructions Manual
TRACTOR
female
male
15
o
15
o
L
2/3 of L
MACHINE