Movement Treadmill R4i Manual De Instrucciones página 95

MAITENANCE
LUBRICATION
The equipment is lubricated at the factory. However, it is recommended to check the
lubrication regularly, to ensure optimal operation of the equipment. It is generally not
necessary to lubricate the belt for the first year or the first 500 hours of use.
After every 3 months of use, lift the sides of the equipment and feel the surface of the
tarp as far as possible. If there are traces of silicone spray, lubrication is not necessary.
For dry surfaces, refer to the instructions below.
Application of lubricant on running belt
•Position the running belt so that the seam is up
•Insert the extender into the lubrication applicator.
•Lift the tarpaulin on one side and position the applicator
under the tarpaulin, place the applicator on the front of the
belt, close to the fairing. Drive the applicator to the rear of
the mat. Repeat this process on the other side of the tarp.
Apply lubrication for about 4 seconds.
• Wait 1 minute to let the silicone spread before starting the
machine.
TREADMILL MAINTENANCE TABLE
Use the table below to know the maintenance frequency.
Problem
The treadmill does
not work
The running belt does not
move properly
The running belt is slipping
Possible cause
a. It is not connected to the power supply.
b. Security key not inserted.
c. Signal cut in the eletronic system.
d. The treadmill does not start.
e. Blown fuse.
a. The running belt is not well
lubricated.
b. Very tight running belt.
a. The running belt is too loose.
.
b The motor belt is too loose.
Corrective measure
Connect to the well outlet.
Insert the security key into the console.
Check the control panel and signal
cable.
Turn on.
Change fuse.
Apply the silicone to the running belt.
Adjust the running belt.
Adjust the running belt.
Adjust the motor belt.
43
PROTRACTOR
APPLICATOR