Movement Treadmill R4i Manual De Instrucciones página 97

MAITENANCE
C: Misplaced speed sensor.
D: Defective speed sensor.
A: Incline motor induction wire is
not well connected.
B: Incline motor AC wire installed
incorrectly.
E4
C: Incline motor connection wire
loose or defective.
D: Do not know how to use the
incline function.
A: Overload and some part is blocked
due to excess current detected in
the self-check.
E5
B: Defective motor and controller.
C: Power and voltage are not in
compliance or are too low.
A: Voltage less than the correct
voltage 50%.
E6
B: Defective controller.
C: Motor connection wire badly
connected.
A: Poorly connected pulse sensor
wire or defective wire.
No pulse
B: Defective console circuit.
Console
A: The screw on the PCB board is
display
loose.
does
B: Defective console.
not light
Install the speed sensor correctly.
Change the speed sensor.
Connect the induction wire correctly.
The AC wire corresponds to the symbol on the
controller.
Change connecting wire or tilt motor.
Press the Learning key on the bottom controller
to review this item.
Adjust the treadmill and restart
Change the engine and controller.
Change the engine and controller.
Perform a new test with the correct voltage.
Change controller.
Connect motor wire correctly.
Connect sensor wire correctly or change the
wire.
Switch console.
Tighten the screw securely.
Switch console.
45