Tools Needed For Assembly; Electrical Requirements - Luminance Brands Kathy Ireland Home ASHLAND CF717AP02 El Manual Del Propietario

1. Unpacking Instructions
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
1.3
Place the Fan Assembly into the upper foam pad with
the top of the Motor facing up .
The upper foam pad serves as a holder for the Fan
during assembly .

Tools Needed for Assembly

One Phillips Head Screwdriver
One 1/4" Blade Screwdriver
One 9/16" or Adjustable Wrench
Materials
Wiring outlet box and box connectors must be of type
required by the local code . The minimum wire would be
a 3-conductor (2-wire with ground) of following size:
Your new Ceiling Fan will require a Grounded Electrical
Supply line of 120 Volts AC, 60 Hz, 15 Amp Circuit .
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable
for Fan Support of 22.7 kg. (50 lbs.) or less", and
use screws supplied with outlet box. Most outlet
boxes commonly used for support of light fixtures
are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
One Stepladder
One Wire Stripper

2. Electrical Requirements

(Continued)
Installed Wire Length
Up to 50 ft .
50-100 ft .
!
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 12).
If you feel you do not have enough wiring knowledge
or experience, have your fan installed by a licensed
electrician.
Controls
SW90 Wall Control (sold separately) may be used
with this 52" Ashland Ceiling Fan . Controls are
recommended for indoor use only .
The Outlet Box must be securely anchored and capable
of withstanding a load of at least 50 pounds .
If your Fan is to replace an existing ceiling light fixture,
turn Electricity Off at the Main Fuse Box at this time and
remove the existing light fixture .
!
To avoid fire or shock, follow all wiring instructions
carefully.
A n y e l e c t r i c a l w o r k n o t d e s c r i b e d i n t h e s e
instructions should be done or approved by a licensed
electrician.
4
Wire Size A .W .G .
14
12
WARNING
(Sold Separately)
WARNING
ETL Model No.: CF717-2