Luminance Brands Kathy Ireland Home AMHURST LED CF880LBS00 El Manual Del Propietario página 22

8. Wall Control Installation
8.5
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker Panel or Main Fuse Box before attempting
to install the Ceiling Fan Wall Control into the Wall Box .
Before installing the Second Wall Control, place the
Wall Control in "OFF" mode by pushing "ON/OFF"
Switch ( ) to the "OFF" ( O ) position .
Install the Second Wall Control (purchased separately)
into the Wall Box containing the "LOAD" Wire .
Connect the Second Wall Control Black Wire labeled
"TO POWER SUPPLY" to the Traveler Wire(s) already
connected to the Black Wire (in the other wall box) .
Secure with Wire Connectors, supplied (Figure 31) .
Connect Second Wall Control Black Wire labeled
"TO FAN" to the "LOAD" (Black) Wire and secure with
Wire Connector, supplied (Figure 31) .
Connect the Second Wall Control Green Ground
Wire to the Supply Ground Conductor (this may be
a bare wire or wire with Green Colored insulation) .
Securely connect Wires with Wire Connector, supplied
(Figure 31) .
Screw the Second Wall Control onto the Wall Box using
the supplied Screws . Leave the Wall Control in "OFF"
mode until Fan installation is completed .
NOTE: Retrofit 3-way installations are likely to
include two traveler wires between the two wall
boxes. In new construction, only one traveler wire Is
required (See Figure 31).
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
All Wall Controls are supplied with a White, Ivory, and
Almond color Switch Covers . Choose the finish that
best suits your needs and snap the Covers onto the
Wall Controls (Figure 31) .
Install Decorative Wall Plates using the two Screws
provided with each Wall Plate . Leave the Wall Control
in "OFF" mode until Fan installation is completed
(Figure 31) .
(Continued)
STANDARD WIRING FOR EXISTING
3-WAY SWITCHES
HOT BLK
GND
3-WAY WIRING DIAGRAM: RETROFIT
ALL WALL CONTROLS
SCREWS (2)
DECORATIVE WALL PLATE
Figure 31
22
EXISTING
EXISTING
WALL SWITCHES
WALL CONTROL
GND
TRAVELER WIRES
FAN/LIGHT WALL
SCREWS (2)
CONTROL
.... ....
OFF
OFF OFF
ON
ON
ON
WALL BOX
SWITCH COVER
ETL Model No.: CF880L
LOAD