IRUDEK SEKURBLOK Manual Del Usuario página 10

CAREFULLY READ THE INSTRUCTIONS BEFORE USING THE FALL ARRESTER
The Retractable Fall Arrester Sekurblok Irudek is classed as Personal Protective Equipment (PPE) by the European PPE
Regulation EU 2016/425 and are in conformity to the European Norm EN 360:2002.
The declaration of conformity is available at the following internet address:
http://www.irudek.com/es-es/descargas/
1 DESCRIPTION
This Retractable Fall Arrester is designed to minimize the risk of/provide protection against the danger of falling from heigts.
However, always remeber that no ítem of PPE can provide full protection and care must always be taken while carrying out
the risk relation activity.
Configuration:
- Retractable Lanyard Made of
Galvanized steel wire of length ...
meters.
- Plastic casing
- Connector 981
- Harness attachment
Swivel Snap hook
976
The block also has a swivel-enabled ring at its Anchorage termination. This special feature allows the Retractable Block to
easily rotate about it axis in case the wire rope unwinds, its twists causing unwanted rotation of the user.
The Swivel Snap Hook Irudek is provided at the harness attachment end of the retractable lanyard, and can be conveniently
connected to the Fall Arrest D-ring of the Harness on the wearer. Th especial swivel action of the hook provides easy
movement of the user at all times without causing untoward twists in the lanyard.
MATERIAL
Wire rope made of galvanized Steel 4,5mm.
HOW TO USE
1/ Connect the swivel eye at the top of the Retractable Fall Arrester to a suitable anchorage point situated
above the user´s head using Karabiners as per EN 362 & ensure the Karabiner is locked.
2/Now connected the swivel hook of the equipment to the attachment element for your full body harness
and ensure that it is locked.
In the event of a fall, the Retractable Fall Arrester locks & also minimizes the impact forces on the body of user to les tan 6
kN.
The equipment is to be used specially in vertical condition.
purpose other than that for which it is intended.
INSTRUCTION FOR USE
1. The Retractable Fall Arrester shall be used only for Vertical movement, up or down.
2. It is recommended that the anchor point where the fall arrest system is going to be
fixed should be placed above the position of the user. Anchor point must have a minimum
static strength of 12 kN and must be in conformity to EN 795 requirements.
3. Do not operate at an angle greater than 40 degrees, to avoid the pendulum effect.
4. Suitable for use only for up to a weight of 140 kg.
5.Allow adequate clearance of minimum 4 meters below, in order to avoid collision
with the adjacent structures or the ground in the event of a fall.
6. Ensure that the Harness complies with EN 361, is adjusted to the user´s size, is free
from damage and is in Good condition.
The wearer must move at a normal walking speed. Acceleration, jumps, etc lock the braking mechanism
GB