Aventics AES Serie Descripción De Sistema página 114

114 AVENTICS | Bus Coupler AES/Valve Driver AV, EtherNet/IP | R412018139–BAL–001–AF
Conversion of the Valve System
Impermissible, non-compliant expansion!
Any expansions or reductions not described in these instructions interfere with the basic
configuration settings. This will prevent a reliable system configuration.
Observe the rules for the expansion of the valve zone.
Observe the specifications of the system owner as well as any restrictions resulting from the
overall system.
You may use the following components for the expansion or conversion of the system:
Valve driver with base plates
Pressure regulators with base plates
Pneumatic supply plates with bridge card
Electrical supply plates with supply board
Pneumatic supply plates with UA-OFF monitoring board
With valve drivers, combinations of several of the following components are possible (see Fig. 16 on
page 115):
Valve driver, 4x, with two base plates, 2x
Valve driver, 3x, with one base plate, 3x
Valve driver, 2x, with one base plate, 2x
If you would like to operate the valve system as a stand-alone system, a special right end plate
is required (see section 15.1 "Accessories" on page 123).
NOTICE