Changing Password; Changing The System Settings - MarelliMotori MEC-100 Manual De Instrucciones

Password entering button

5.4.2. Changing Password

To modify the password:

Click on the Tools item in the menu bar of the MEC-100 Interface System (see Fig. 5.4.2.a).

In the displayed pull-down menu, point to the Modify Password item and click.

In the window which appears enter the current password in the Previous Password field and the desired
password in the New Password field; afterwards enter the desired new password again for confirmation in the
Confirm Password field (see Fig. 5.4.2.b).

Click OK.
Selecting Change Password

5.5. CHANGING THE SYSTEM SETTINGS

As anticipated in Par. 5.3.2., the system parameters are grouped into eight main categories according to their typology:

System parameters.

Sensing.

Setpoint.

Stability.

Other settings.

Limiters.

Field protections.

Generator protections.

Diode monitoring.
Each category can be selected by the relevant button in the frame indicated Fig. 5.5.a. After selecting one of the categories, the
corresponding set of parameters is displayed. If connected to the MEC-100, the above-mentioned set of parameters can also be
configured.
A parameter can be configured by clicking in the appropriate field and typing the desired value or selecting the desired option
between the available options. In any field you can only enter values falling within determined limits, established on the basis of
the parameter type, the particular application and the other set parameters. The limits are normally indicated next to the name of
the parameter to be configured. If you try to enter a value outside the allowed range a red exclamation mark will appear next to
the entered item. After configuring a group of parameters, you need to send the entered data to the MEC-100 before switching
to the next group; otherwise, the typed data will be lost.
963857137_G
Fig. 5.4.1.a
Fig. 5.4.2.a
Fig. 5.4.1.b
Entering the password
Fig. 5.4.2.b
Entering a New Password
MEC-100
82