Assembly & Operation - Worx WG183 Manual De Instrucciones

P
ASSEMBLY & OPERATION
ACTION
Assembly
Assembling the Trimmer Shaft
Assembling the Auxiliary Handle
Assembling the Safety Guard
Installing and Removing the
Battery Pack
NOTE:
• This machine will only run
when 2 batteries are installed.
It is recommended to use the
same two batteries and charge
the two batteries at the same
time.
• When you use two batteries
with different power, the
machine will only run to the
lower common denominator.
Charging the battery pack
NOTE:
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
Battery power indicator on the
machine
See details in BATTERY STATUS
section
OPERATION
Cordless Grass Trimmer
On/Off Switch
FIGURE
the trimmer has been switched
off; wait until it has completely
stopped then lay down the tool.
See Fig. A
Trimming
See Fig. B
-Adjusting the Auxiliary handle
See Fig. C
Manually feeding the line
Removing the Cap
Cutting Head
Changing the line spool
See Fig. D1, D2
Manually winding the line
BATTERY STATUS (See Fig. D4)
Before starting or after use, press the button beside
the power indicator light on the machine to check the
battery capacity. During operation, the battery capacity
will be indicated automatically by the battery power
indicator.
The indicator constantly senses and displays the battery
condition as follows.
For the machine with 2 battery packs with different
power, the power indicator light displays the battery
See Fig. D3
condition with the lower one of the two batteries.
Five green lights
See Fig. D4
(
illuminated.
Q
WARNING! The cutting head
continues to rotate after
Battery power
indicator status
The two batteries are in a highly
) are
charged condition.
See Fig. E
See Fig. F
See Fig. G
See Fig. H
See Fig. I
See Fig. J
See Fig. K,L
See Fig. M, N,O,P
Battery condition
EN
9