VACHERON CONSTANTIN TRADITIONNELLE AUTOMATIKAUFZUG EXTRA-FLACH SKELETT Manual De Instrucciones página 5

Setting instructions
Winding and setting the time:
The winding and time-setting crown (I) can be placed in any of two
positions: A and B.
A: Pushed down against the case, winding position.
This is the normal position when the watch is being worn; it
guarantees optimum water-resistance.
If the watch has not been worn for some time, wind it by rotating
the winding and time-setting crown (I) a few times. A watch need
not be fully wound if it is going to be worn. At the end of the winding
operation the winding and time-setting crown (I) will not be blocked
and the mechanism therefore cannot be damaged.
B: Time-setting position.
When the winding and time-setting crown (I) is pulled out to this
position, the time can be adjusted. Turn the winding and time-
setting crown (I) until the hands point to the desired time. Then push
the winding and time-setting crown (I) back down to position A.
10
Water-resistance
The water-resistance of the watch has been tested at a pressure
of 3 bar.
11