Troubleshooting - Harbor Breeze CFH52BNK5L Manual De Instrucciones

TROUBLESHOOTING

WARNING: Before beginning work, shut off the power supply to avoid electrical shock.
PROBLEM
Fan does not move.
Noisy operation.
Excessive wobbling.
Fan operates but
light fails.
NOTE: A small amount of "wobble" is normal and should not be considered a defect.
POSSIBLE CAUSE
1. Reverse switch not engaged.
2. Power is off or fuse is blown.
3. Faulty wire connection.
4. Plugs in fitter plate not connected
properly.
1. Blades are loose.
2. Cracked blade.
3. Full range dimmer switch.
4. Fan is new.
1. Blades are loose.
2. Unbalanced blades.
3. Fan not securely mounted.
1. Wires in motor housing not wired
properly.
2. Wall switch to fan is off.
3. Wires in LED light kit not wired
correctly.
CORRECTIVE ACTION
1. Push switch firmly either left or
right.
2. Turn power on or check fuse.
3. Turn power off. Loosen canopy
and check all connections.
4. Check that male and female plugs
in fitter plate are connected
properly according to instructions
on page 11.
1. Tighten all blade screws.
2. Replace blade.
3. Replace with an approved speed
control device.
4. Allow fan a "break in" period of
a few days, especially when
running the fan at Medium and
High speeds.
1. Tighten all blade screws.
2. Switch one blade with a blade
from the opposite side.
3. Turn power off. Carefully loosen
motor housing and verify that
mounting plate is secure.
1. Check wires in motor housing
and, if necessary, re-wire
according to instructions on
pages 8 and 9.
2. Make sure that wall switch to fan
is on.
3. Check that molex connections in
LED light kit are connected
properly according to instructions
on page 11.
15