Yakima Q Towers Manual De Instrucciones página 4

Attach the Rack to your vehicle.
INSTALL CLIPS:
• Line front and back of clips with black vinyl
liners; trim if necessary.
• Slip lined clip
into tower
through slits
on side.
Fine tuning the tower tension:
• Gold sliders should be an equal distance
from the slider marks on each Tower.
• IF the gold sliders are not equal
distances, loosen or tighten screws
until sliders are equal.
CLIP
SAFETY
CHECK
– KEEP SLIDER MARKS EQUAL –
1033071A-4/15
Install lock holder &
U-shaped fastener:
• Insert lock holder into holes in clip and
tower, matching notches.
• Push U-shaped fastener over lock holder.
It should feel snug.
• Repeat for other Tower.
WITH DOORS OPEN:
• PULL each clip away from car—
PULL HARD!
• DO THIS FOR EACH CLIP.
• If clip moves, open cover and
tighten screw. Close cover and
check clip again.
• If it still moves,
check M1 and M3 measurements
and re-tighten.
Secure the rack to car's roof:
• Tighten one side slightly so that cam cover
closes with light pressure—and without moving
the Tower. Do not overtighten. Close cover.
• Go to opposite side, tighten screw
slightly, close cover.
• Tighten each side as evenly as
possible—a few turns on one Tower,
then a few on the other. Open and
close cam covers with each
adjustment.
• Tighten until the covers close
firmly—with some resistance.
This needs to be done gradually
to prevent the Towers from
moving off center.
NOTE:
The gold slider
should NEVER
TOUCH the crossbar.
TOWER
SAFETY
CHECK
SAFETY CHECK
PULL Clips, GRAB Bars
Check clip
instructions in
clip box for
special NOTES
that may apply to
your car.
The gold sliders may fall
below or cover up slider
marks depending on the
make of car.
WITH DOORS OPEN, CHECK BOTH TOWERS:
• Grab bar on inside of Towers, push & pull (use
arm strength, full body strength not necessary).
Tower should not move.
• If Towers move, tighten screws slightly.
• Keep slider marks equal.
• Close cover and check again— if towers move,
check measurements again.