Yakima Q Stretch Kit Manual De Instrucciones página 5

INcReAse The TOWeR TeNsIONs equAlly.
• start with six half turns
on each side.
• then tighten each side
with a few turns each.
• With each adjustment, close cam
covers checking the positions.
TIGhTeN GRADuAlly to prevent
rear towers from moving off
center as tension increases.
P e R f O R M s A f e T y c h e c k s W I T h c A R D O O R s O P e N .
checK each
clIP!
Pull each clip away from
car. Pull hARd!
if any of the clips or towers move, check the gold slider positions,
tightening adjustment posts gradually. (if there is still movement after
fine tuning, verify the M1 and M3 measurements.)
ReMOvING The RAcks
Read the warnings and cautions on the last page of your Q-tower instructions. Refer to your yakima Q-tower instructions for yakima's limited Warranty.
1033431C - 5/15
Watch rear
towers!
Rear towers must
remain equal distances
from sides of car.
checK fronT
Towers!
grip the bar inboard to towers; push
and pull using only arm strength.
• unlock towers and open
cam covers.
• unhook and remove
stretch kit bars.
• Remove rear crossbar
and towers.
• Remove front crossbar
and towers.
This product is covered by YAKIMA's "Love It Till You Leave It" Limited Lifetime Warranty
To obtain a copy of this warranty, go online to www.yakima.com
or email us at yakwarranty@yakima.com or call (888) 925-4621
k e e P T h e s e I N s T R u c T I O N s !
cam covers mUsT close wITh
fIrm resIsTance!
if the covers close too
easily, check the gold
slider positions, tightening
adjustment posts gradually.
grip the bar
outboard to
towers; push up
using only arm
strength.
Rear towers must remain equal
distances from sides of car. if
they are unequal, loosen the
tower that is farthest outboard
INsTAllING RAcks AGAIN
• open cam covers.
• Clean roof and place towers at m and m4 positions;
measure carefully.
• Attach stretch kit bars.
• make sure clips are seated properly, then close cam
covers with firm resistance.
PeRfoRm sAfety CheCks on All toWeRs And
CliPs AfteR eveRy instAllAtion!
gold sliders must
be aligned!
checK rear
Towers!
rear Tower
PosITIons:
and tighten the other.