Yakima Q Stretch Kit Manual De Instrucciones página 4

The fRONT TOWeRs AND bAR
shOulD AlReADy be INsTAlleD.
• open car doors.
• set rear rack on the roof.
POsITION ReAR RAck.
• use m4 measurement (from clip sheet,
or at yakima.com).
• measure from centers of crossbar ends.
M4
PRePARe TO INsTAll
The sTReTch kIT.
- the stretch kit has a left and a Right tube.
- the tubes slide to adjust.
- the housing holds the rear clip assembly.
slide each hook into the rectangular
opening on the back of the towers.
slide both housings to the
ReAR of the CAR until they stoP
(unless a measurement is noted in
your Clip instructions).
1033431C - 4/15
ATTAch The ReAR cOveRs.
• secure with screws.
• tighten with Q-tower wrench or 4 mm hex wrench.
tubes
(stop
buttons)
tube hook
sleeve hook
Attach a clip holder assembly to one
of the housings.
• engage the adjustment post with six-half turns.
• Repeat for other side, six half-turns only.
be sure the towers are an
equal distance from the edge
of the roof on each side.
housing
sleeves
(front of car)
HOOK IN AND DOWN.