Yakima Q Stretch Kit Manual De Instrucciones página 3

If yoU already have a roof racK InsTalled
OPEN CAR DOORS.
CAm
CoveR
Adjustment
sCReW
ReMOve The ReAR RAck AND seT IT
ON A sTuRDy flAT WORk suRfAce.
Refer to Q-tower instructions.
Find the measurement for your car
wITh a Q-sTreTch KIT.
• find your car's m3 in the clip sheet, or at yakima.com.
• loosen the toWeRs.
• Position towers at the new m3 distance, measuring
from inboard tower edges.
On a flat surface...
1. Completely tighten first tower screw.
2. Apply firm downward pressure to
crossbar and tighten second tower.
After tightening both towers, measure again
to be sure the towers have not moved.
1033431C - 3/15
• open the rear tower cam covers.
• Completely unscrew the adjustment screw.
• Carefully lift out the rear clip holder assemblies, and set aside.
CliP
holdeR
Assembly
3 3
M M
M
then snap towers closed.
3
When using the
wrench, insert the
short end, and
hold the long
seCtion.
"snAP"