Notch 54440 Instrucciones De Uso página 12

2 \ NOMENCLATURE
Wrench Connection Point / Spring, (3) SRS Ascent Attachment Points (4)
Tether Body, (5) Secondary Attachment Point, (6) Hitch Tending Pulley, (7)
Main Attachment Point
3 \ INSPECTION AND POINTS TO VERIFY
Before Each Use
• Check all parts for cracks, deformation, corrosion, wear, sharp edges,
burrs and proper condition.
• Verify proper movement of the Rope Wrench Connection Point, when
connected the Rope Wrench should rotate to the limited distance set
by the Rope Wrench Connection Point.
• Verify the SRS Ascent Attachment Points and Secondary attachment
point are accessible.
• Verify the Pulley rotates freely.
• Verify the Pulley side plate opens without interference.
• Check that the Main Attachment Point is free of any obstruction.
• User must understand the correct usage and functionality of
ING
the Rope Wrench, refer to manufacturers instructions.
IMIT
• If product does not pass all inspection points it should be
removed from use.
During Use \
uct and the connectors of the climbing system. Ensure all components
of the equipment are correctly positioned with respect to each other.
Detailed Inspection \
after each use, a detailed inspection by a competent inspector must be
done at least every 12 months or more frequently depending on amount
and type of use. Make a copy of these instructions and use one as the
permanent inspection record.
4 \ COMPATIBILITY
components of the system in the application (compatible = good func-
tioning interaction). (Fig 4A-4C)
Equipment used with the Fusion Rope Wrench Tether must meet the
appropriate standards in your country. The Fusion Rope Wrench Tether
is ONLY approved with the use of arborist grade ropes with a diameter
between 11 – 13mm which meet the ANSI Z133-2017 standard. When
using multiple pieces of equipment as a system, instructions for each
piece of equipment must be followed.
ZK1 model Rope Wrench is not compatible with the Fusion Rope
Wrench Tether.
factors, condition of rope, hitch cordage, and condition of the Fusion
Rope Wrench Tether.
The Fusion Rope Wrench Tether is ONLY compatible with triple-action,
double locking carabiners.
5 \ INSTALLATION
Rope Wrench. (Fig 5A)
• Remove the Steel Slic Pin from the Rope Wrench, unscrew and
remove the Rope Wrench Tether Attachment Point Bolt.
• Place the free end of the Fusion Rope Wrench Tether between the
side plates at the Tether Attachment Point.
• Reinsert and secure the bolt (It's recommended to apply thread
locking fluid prior to re-securing the bolt).
• This completes the initial Rope Wrench installation, it's not recom-
mended nor necessary to detach the Fusion Rope Wrench Tether
once connected to the Rope Wrench.
12
Regularly inspect and monitor the condition of the prod-
WARNING: Product performance can be affected by environmental
WARNING: Bolt at the Tether Attachment Point may come
(1) Tether Attachment Point Bolt, (2) Rope
In addition to inspection before, during, and
Verify the product is compatible with other
Connect the Fusion Rope Wrench Tether to