Tabla de contenido
Publicidad
Steps
1. Place the power button into its slot on the computer.
2. Replace the two (M2x3) screws to secure the power button in place.
Next steps
1. Install the
power button
2. Install the
heat-sink
assembly.
3. Install the battery.
4. Install the
base
cover.
5. Install the
SD
card.
6. Follow the procedure in
Ensamblaje del botón de encendido con lector de
huellas digitales
Removing the power button assembly with fingerprint
reader
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the battery.
5. Remove the
heat-sink
assembly.
6. Remove the
power button board assembly with fingerprint
About this task
The figure indicates the location of the power button and provides a visual representation of the removal procedure.
board.
after working inside your
computer.
before working inside your
computer.
reader.
Desmontaje y reensamblaje
59
Publicidad
Tabla de contenido
