Tabla de contenido
Publicidad
Steps
1. Remove the two (M2x3) screws that secure the power button assembly with fingerprint reader in its slot on the computer.
2. Remove the power button assembly with fingerprint reader from the computer.
Installing the power button assembly with fingerprint
reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power button and provides a visual representation of the installation procedure.
Steps
1. Place the power button assembly with fingerprint reader into its slot on the computer.
2. Replace the two (M2x3) screws to secure the power button assembly with fingerprint reader in place.
Next steps
1. Install the
power button board assembly with fingerprint
2. Install the
heat-sink
assembly.
3. Install the battery.
4. Install the
base
cover.
5. Install the
SD
card.
6. Follow the procedure in
60
Desmontaje y reensamblaje
after working inside your
computer.
reader.
Publicidad
Tabla de contenido
