Tabla de contenido
Publicidad
4. Remove the display cable from the display back cover.
Installing the display cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the display cable and provides a visual representation of the installation procedure.
Steps
1. Route and adhere the display cable on the display back cover.
2. Connect the display cable to the connector on the camera module.
3. Adhere the adhesive tape to cover the camera module.
Next steps
1. Install the
P-sensor
board.
2. Install the
display
panel.
3. Install the
display
bezel.
4. Install the speaker.
5. Install the
display
assembly.
6. Install the
system
board.
7. Install the
GPU
card.
Desmontaje y reensamblaje
95
Publicidad
Tabla de contenido
