Metrohm 799 GPT Instrucciones Para El Uso página 166

3.2. Remote control commands
162
Config.Aux.Set.Time
Date and time.
Input format of the date: Year-month-day, two-digit, enter leading zeros.
Input format for the time: Hours:minutes, two-digit, enter leading zeros.
Date and time have to be set with &Config.Aux.Set $G just after entry of the
value.
3.2.2.102. Config.Aux.RunNo
Current sample number.
Set to 0 on power on and initialization. After 9999, counting starts again at 0.
3.2.2.103. Config.Aux.AutoStart
Number of automatic, internal starts.
3.2.2.104. Config.Aux.StartDelay
Start delay time in s. During this time, the data of the preceding determination
are retained.
3.2.2.105. Config.Aux.ResDisplay
Character set for the result display at the end of the determination.
3.2.2.106. Config.Aux.DevName
Name of the instrument for connections with several units. It is advisable to
use only the letters A...Z (ASCII No. 65...90), a...z (ASCII No. 97...122) and
the numbers 0...9 (ASCII No. 48...57) when the function Setup.AutoInfo
(3.2.2.169) is used at the same time.
If a name has been entered, it will be printed out in the result report (full,
short).
3.2.2.107. Config.Aux.Prog
Output of the program version.
The Titrino sends "799.0010" on requests with $Q.
3.2.2.108. Config.RSSet1
Config.RSSet1.Baud
Config.RSSet1.DataBit
Config.RSSet1.StopBit
Config.RSSet1.Parity
Config.RSSet1.Handsh
$G sets all RS settings. The changes are performed only if the instrument is
inactive. After the setting of the interface parameters, wait at least 2 s to allow
the components to equilibrate.
Settings of the values for the data transmission via the RS interface: baud
rate, data bit, stop bit, parity and type of handshake, see also page 180 ff.
1...9999, OFF
bold, standard
up to 8 ASCII characters
300, 600, 1200, 2400, 4800, 9600,
19200, 38400, 57600, 115200
even, odd, none
HWs, SWchar, SWline, none
HH:MM
0...9999
0...999 999
read only
$G
7, 8
1, 2
799 GPT Titrino