Product Start; Product Pause; Product Stop; Product Restart - ECOVACS WINBOT 7 Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4.2 Product Star t

4.3 Product Pause

4.4 Product Stop

4.5 Product Restar t
Once the unit is attached to the window, press the Start/Pause button on the
unit or the Start/Pause button on the Remote Control. The Winbot will use its
automatic cleaning mode to clean the window.
NOTE:
Winbot can NOT be used to clean stains such as paint, or windows with
stickers attached, as these may cause suction failure.
Windows with uneven surfaces, such as frosted, textured, patterned or
leaded glass are not suitable to be cleaned by the Winbot.
Windows with a film, coating or tint are not suitable to be cleaned by the
Winbot as it may damage the coating.
After Winbot has finished cleaning one window, if the Cleaning Pads are
excessively dirty, please replace them with a clean, completely dry set.
Cleaning Pads are machine washable. Extra sets of Cleaning Pads can be
purchased by calling Customer Service at 1-888-966-0895.
Do NOT use the unit outside when it is raining, snowing or colder than 40º F as
it could damage the product and could cause electrical problems.
If the product needs to be paused during the cleaning process, press the
"Start/Pause"
button on the Remote Control or press the "Start/Pause"
.......
button on the unit. The product will pause and wait for further
instructions.
While the unit is in the Pause Mode, the Remote can be used to move the unit
around the window to clean any area by pressing the appropriate directional
arrow. To return the unit to automatic mode, press the "Start/Pause"
button on the Remote Control or directly on the unit.
After the Winbot has finished cleaning the window, it will return to the place it
started, emit a song and the Indicator Light will flash BLUE. If the stopping
location is not convenient to remove the unit, use the Remote Control to move
it by pressing the appropriate directional arrow until the unit is where you can
grasp the handle more conveniently.
To remove the Winbot from the window, grasp the handle of the unit, move the
switch under the handle to the OFF position (far left). While still grasping the
unit, insert finger into the Air Release Trigger and pull up on it. Remove the unit
from the window when the suction has diminished.
Use the Finishing Cloth to wipe away any mark left from removing Winbot.
Do NOT try to use the handle as leverage to pry the unit from the window as that
could damage the product. If the Air Release does not work, hold the handle
for 45-60 seconds and the unit will release itself from the window.
Always store the unit with the switch in the OFF position (far left) and in the
original box, if possible.
If the unit cycles in a place repeatedly during operation, or stops working, and
sends a warning sound and a RED Indicator Light flashes, grasp the unit by
the handle and turn the switch to the OFF position (far left). Then, turn the
switch to the ON position (center) and press the Pause/Start button on the
Remote Control or the unit to continue the cleaning process.
If using Winbot continuously for a long period of time, it is recommended
to give Winbot a 10 minute break for every hour of use. This will extend
the life and performance of robot and prevent overheating.
Live Smart. Enjoy Life.
EN
10

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido